![]() Curtain rod sets include a rod, finials, wall brackets, a rod holder and a connector for additional rods that open up endless possibilities for other additions. You can choose complete curtain rod sets in a variety of looks that include everything you need to dress your window except the curtain. Hang the curtains with ease with drapery rods that are a cinch to place close to the ceiling as the brackets are assembled underneath. Options in modern, stylish metal curtain rods range from white, black, nickel-plated or ones with the look of brass. Take care not to damage the slot of the curtain track when drilling or mounting the track.Selecting the right long curtain rods is easy-especially with options in metal drapery rods with an adjustable length. After confirming that the pilot hole is centered in the correct position, use an appropriate bit that creates holes that will accommodate your screws of bolts. Standard drill bits work fine on all aluminum tracks. Using a small bit, drill pilot holes centered in the slot through the top of the track. ![]() To drill holes, identify where the holes should be positioned and mark the track. Most curtain tracks do not have the mounting holes pre-drilled. For systems where a master carrier is not offered, you can also add an additional carrier between the 1st and 2nd carrier on each panel, allowing a free carrier that can be used to support a baton or wand. Some curtain track systems offer master carriers that allow for easy attachment of a wand or baton to draw curtains or draperies open or closed. All Curtain-Track systems are hand-drawn systems. CORD DRAWN TRAVERSE RODS AND TRACKSĬ does not offer cord drawn systems. When installing tracks to be used with two-way draw curtains that meet in the middle, it is advisable to center the seam so that carriers are not traveling over the seam. Often, the use of a laser level can assist in marking consistent mounting locations to assist with this alignment. In either case, it is important to fully align the tracks to minimize the seam and thus reduce the likelihood that carriers jam in transit. Some track systems offer splicers that connect the track sections, while others require that the tracks be aligned and abutted during installation without additional hardware. Wider applications may require that tracks be mounted end to end. ![]() Anchors can also be used when sheetrock offers the only attaching surface. It is advisable to attach tracks and brackets to ceiling joists and wall studs or other solid supporting surfaces whenever possible. When selecting screws/bolts that are to be inserted through the slot in a track, be sure to consider that the head of the screw/bolt must fit clearly through the slot without marring the track. FASTENERSĬ does not sell mounting fasteners (screws, toggle bolts, anchors, etc.) as specific installations vary widely, and can best be addressed at your local hardware store. Review the topics below for more information, and download the specific installation instructions to aid you with your project. ![]() You should use good judgment in assessing the mounting surface to be sure the tracks will be adequately supported. With the use of simple tools (drill, screwdriver, laser level, miter saw), the installations can be completed fairly quickly. The installation of these curtain track systems is not complicated and can be completed by most Do-It-Yourselfers (DIY’s). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |